IviCounter Simulator Setup Dialog Box
You can use two sets of properties with the IviCounter Simulation Driver. Use the dialog box shown in the following figure to configure the measurement simulation for the IviCounter Simulation Driver.
Simulator Setup Dialog Box
Always prompt for output data simulation
Leaving this control selected causes the panel to appear at every measurement acquisition event in your program. All simulated acquisitions in the program use the same measurement configuration information. Deselecting this control causes the measurement simulation panel to never appear again during the course of your program.
Force Uncalibrated
Select this control if you want to force an uncalibrated condition to occur during measurement events. When you enable this option, all measurements simulate an uncalibrated measurement condition by returning an uncalibrated warning as the return status.
Force Over-Range
Select this control if you want to force an overrange condition to occur during measurement events. When you enable this option, all measurements simulate a measurement over-load condition by returning an overrange warning as the return status.
Measurement Base
Enter the measurement base to use for all computer-generated measurements. All computer-generated measurement values fall within the range of this value plus or minus the value of the Measurement Noise control.
Valid Range: any value
 |
Note The unit of this value is determined by the IviCounter Measurement Function property. |
Measurement Noise (+/-)
Enter the reading noise to use for all computer-generated measurements. All computer-generated measurement values fall within the range of the value of the Measurement Base control plus or minus this value.
Valid Range: any positive value
|
Note The unit of this value is determined by the IviCounter Measurement Function property. |